Laboratory carried out by: ..........................................................
1. Calculation of the module of the gear.
Fig 2.1.Measurement scheme.
General normal of the teeth was measured by means of a caliper, with the value of the reading of the rule 0,02 mm. The number of the teeth of the wheel z = 17.
The number of the teeth enveloped by caliper zn = 2.
The data of the general normal length measurements as follows:
Step on the base circle:
Calculated module:
mm.
Real module of the gear wheel m = 8 mm.
2. Calculation of the displacement coefficient:
The width of the tooth on the base circle:
Displacement coefficient:
3. Calculation of the addendum circle and the dedendum circle.
Fig 2.2. Scheme of the determination of addendum and the dedendum circles.
Measurements are taken with the help of...
Šį darbą sudaro 336 žodžiai, tikrai rasi tai, ko ieškai!
★ Klientai rekomenduoja
Šį rašto darbą rekomenduoja mūsų klientai. Ką tai reiškia?
Mūsų svetainėje pateikiama dešimtys tūkstančių skirtingų rašto darbų, kuriuos įkėlė daugybė moksleivių ir studentų su skirtingais gabumais. Būtent šis rašto darbas yra patikrintas specialistų ir rekomenduojamas kitų klientų, kurie po atsisiuntimo įvertino šį mokslo darbą teigiamai. Todėl galite būti tikri, kad šis pasirinkimas geriausias!
Norint atsisiųsti šį darbą spausk ☞ Peržiūrėti darbą mygtuką!
Mūsų mokslo darbų bazėje yra daugybė įvairių mokslo darbų, todėl tikrai atrasi sau tinkamą!
Panašūs darbai
Kiti darbai
Atsisiuntei rašto darbą ir neradai jame reikalingos informacijos? Pakeisime jį kitu nemokamai.
Pirkdamas daugiau nei vieną darbą, nuo sekančių darbų gausi 25% nuolaidą.
Išsirink norimus rašto darbus ir gauk juos akimirksniu po sėkmingo apmokėjimo!